14 — Industry

Electrical engineering design for electronics and battery manufacturing

Battery and electronics manufacturing grows faster than standards can establish themselves. Plants are built in parallel with product development and changes arrive during commissioning. That calls for a documentation structure that tolerates change rather than punishing it.

Typical tasks

Electrical design of near-cleanroom production and handling systems.
Test systems with a high density of measurement channels.
Control cabinet layout under tight space and cleanliness requirements.
Cable routing and harnesses in densely packed machines.
Documentation that carries frequent changes during commissioning.

What we take on

Electrical design for production, assembly and test systems.
3D layout planning and wire harness design.
Support during commissioning with documentation maintained as you go.
Building a structure that carries later product generations.

Engineering software & CAE systems

We work inside your system landscape.

For electrical design and technical documentation we use established CAE systems. Which one we use follows your standards and your existing environment – not our habit.

EPLAN Electric P8
Electrical design & schematics
- Circuit diagrams
- PLC & I/O
- Terminals & cables
- Reports
EPLAN Pro Panel
3D control cabinet & layout planning
- Layout planning
- Component placement
- Wiring
- Manufacturing data
EPLAN Harness proD
Wire harness & cable routing
- Routing
- Cables
- Connectors
- Wire harnesses

Technical framework

In this industry a plant is rarely finished at commissioning. So we plan the documentation from the outset as something that changes – with clean version control instead of retrospective correction loops.