06 — Services
Schematic generation & configuration
There are plants where a hundred conveyor sections mean the same drawing a hundred times, with four changed values. Doing that by hand is not only expensive, it is the most reliable source of error in electrical design.
Why FISEKON
We take on the electrical design there is no time for in house.
- 28
- Years of electrical design
- 14
- People
- 3
- CAE systems in house
- 2
- Locations in Westphalia
One contact, not a distribution list
Whoever takes your project also works on it.
Your CAE system, not ours
EPLAN, WSCAD, ELCAD — with your part master.
Existing plants are our everyday work
Plant runs, documents do not match. That is where we start.
Capacity without a permanent post
Design capacity when you need it.
When this service is needed
- A plant consists of many identical sections or drives.
- Product lines differ only in a few parameters.
- Engineering time is the bottleneck, not the design idea.
- Deviations between identical plant sections are accumulating.
Result
- Verified macro library as the generator basis
- Configuration structure and generator rules
- Documentation of designation and address assignment
- Check routine for generated projects
A generator whose output nobody checks will distribute one error reliably across the entire plant. That is why the check routine is part of the delivery.
Process
How we work together
- 01
Check suitability
First we establish whether the setup pays at all. For that we look at variance: what really changes between two plant sections?
- 02
Harden the macros
A generator is only as good as the macros beneath it. These are checked, harmonised and documented before anything is generated.
- 03
Build the rules
Configuration structure, designation assignment and reports are set up and tried on a real plant section.
- 04
Handover
You receive the generator with documentation and check routine. We accompany the first projects.
Questions about this service?Show contact
Where plant sections repeat, the schematic can be generated instead of drawn. The basis is verified macros and a configuration table: which drives, which sensors, which addresses, which designations. From that the complete project is produced.
The gain is not only time. A generated project is internally consistent, same structure, same naming, same terminal logic on every page. Where a hundred pages are drawn by hand, a hundred opportunities for deviation are created too.
We build the generator rules, verify the underlying macros and accompany the first runs. After that you can generate yourself or we do it project by project.
What matters is the honest upfront check of whether the setup pays. With five variants, rarely; with fifty, almost always. We tell you that beforehand, not afterwards.
Industries where we take this on
Frequently asked
From what quantity is this worthwhile?
As a rough guide: from around twenty identical units it becomes interesting, from fifty it is almost always economical. What decides is not the number alone but how stable the variance is, frequently changing requirements eat the advantage.
Do we stay dependent on you afterwards?
No. The generator runs in your environment, the rules are documented and your designers are trained. Whether you generate yourself afterwards or commission us is your decision.
Contact
Tell us what it is about.
A phone call or three lines is enough. From the very start you talk to the people who will later work on your project, not to a distribution list.
Your contact
- Phone+49 5332 9464120
- Mobile+49 151 20045434
- Emailkrto@fisekon.com
- AvailabilityMon – Fri, 8:00 – 17:00 CET
Switchboard
- Phone+49 (0) 5247 4070-66
- Emailinfo@fisekon.com
- AvailabilityMon – Fri, 8:00 – 17:00 CET
Locations
33428 Marienfeld (Harsewinkel)Gütersloh officeWagenfeldstr. 2
33332 Gütersloh
Or write to us
We usually reply within one working day.