06 — Industry

Electrical engineering design for energy technology and renewables

Energy technology changes faster than its plants. A boiler runs for decades while its controls reach end of life much sooner; a storage system or electrolyser is added and has to fit into grown infrastructure. In both cases, the transition is the actual service.

Boiler plant with burners, pipework and control cabinets in a heating centre

Typical tasks

Modernising control systems during ongoing operation.
Integrating new generators and storage into existing infrastructure.
Documenting switchgear and distribution systems and keeping them revision-proof.
Recording the installed base where documents are incomplete or outdated.
Continuing the documentation across the whole plant life cycle.

What we take on

Electrical planning of the modernisation.
Design and implementation of the control logic.
Detailed documentation for a seamless transition.
Ongoing upkeep of the documents, under a maintenance agreement if wanted.

Engineering software & CAE systems

We work inside your system landscape.

For electrical design and technical documentation we use established CAE systems. Which one we use follows your standards and your existing environment – not our habit.

EPLAN Electric P8
Electrical design & schematics
- Circuit diagrams
- PLC & I/O
- Terminals & cables
- Reports
ELCAD
Electrical engineering & technical documentation
- Circuit diagrams
- Existing plants
- Revisions
- Plant documentation
WSCAD
Electrical design & schematics
- Circuit diagrams
- Documentation
- Existing projects
- Revisions

Technical framework

We document so that maintenance and later adjustments remain possible without us. A plant operator should not depend on their design contractor.

A project from this industry

Modernisation of heat generators

Electrical planning and modernisation of the control systems of existing steam and hot water boilers – integrated into the infrastructure already in place.

Learn more